As I began installing track on the Baltimore & Ohio Wheeling Freight Terminal model railroad project, I developed a set of processes to prepare track sections for installation. While working through this project, I felt these processes and tips should be posted so readers can benefit from my experiences. I will be running steam locomotives so extra care and attention needs to be taken when installing track for smooth operation.
Rail Prep
Rail joints are common places where derailment problems can occur. I carefully prepare each rail joint. I have seen too many modelers rush through this important step and make a sloppy rail joint. Diesels are forgiving of some sloppy track, but not many steam locos.
Any rails that will be connected more track will need to have the rail ends prepared using a jewelers file and a mill file. If the rail needs to be cut with a motor tool or rail nippers, then the freshly cut rail ends need to be squared up. The image below illustrates what the rail looks like after being cut with rail nippers. A few passes with a mill file will smooth out a rail end. Click on either of the following images for a much larger size.
File the rail bottom lightly to remove any rough edges, then use a jewelers file to add slight tapers to the base of the rail at the end. These tapers ease the installation of a rail joiner. The tapers are the shiny parts at the base of the rail in the image below. This is a completed track section prepped and ready to install.
I also run the file lightly over the top end of the rail and along each side to remove any burrs left from cutting or filing. Once the end is prepped, it can be connected to another rail. I do this with whatever rails have been cut as well as rail on new track right from the box. A little extra care at this stage will ensure better operation later. Keep a brass wire brush handy to clean excess metal out the files when you are done.
If you solder your rail joints, use a wire brush in a motor tool to clean off any oxidation or dirt. A clean surface will solder easier and you’ll be surprised when you don’t melt any ties!
I welcome your comments here. All comments are reviewed and approved before they appear here.